2006 ski-doo track

**roskos** · 11-14-2007, 03:52 PM

I have a 2006 ski-doo rengade 600 ho sdi stock engine wise, but i want to put a new track on,its a 1 and 3/4 paddle does anybody know if i have to do anything to the clutch or anything like that for it to work???

**jakester27** · 11-15-2007, 10:07 PM

You shouldnt because the clutch should turn the new track the same as the old one. The only thing i would worry about is hitting the paddles on the tunnel or heat exchanger...

**Howler** · 11-16-2007, 07:27 AM

You may need to change the gearset if you go bigger on the track lug. What size was the origional? A lot of people forget about the added amount of surface area when they go to a longer lug or paddle. The rpm loss can be huge. Yeah, a clutch may hold it if your set up heavy, but it's only a short term fix. To get the most rip in the deep stuff, the gears are the best bet. My .02.

**roskos** · 11-16-2007, 11:41 AM

The original track lug height is 1.25'' and i want to go to a 1.75''. And do you think i will hit the heat exchanger or the tunnel???

**hcaam** · 11-16-2007, 10:21 PM

you can even run a 2 inch track without clearance problems on the revs. As far as gearing the x models that came with that had the same gearing as the 1.25. If you go up in elevation you might think about gearing down. Y

**jakester27** · 11-17-2007, 08:24 AM

Originally Posted by roskos

The original track lug height is 1.25'' and i want to go to a 1.75''. And do you think i will hit the heat exchanger or the tunnel???

The only reason I thought that is because when i bought studs, the salesman told me not to go any taller that 1.5" because then there may be clearance issues...